Veco 19 GP BB RC

[XMoney]

Hello, Am new to the forum. I am needing a little help on a Veco 19 GP BB RC . I think this was an engine that was in a car or boat. It came with a big drive pulley, and carb installed with the throttle lever that closes on the exhaust port. My question is : Can this engine be used in aero ? It has a mount that is over the nose of the engine and it has a bearing in it and, it has a set of mtg. holes in it. Can anyone help me out. I can take a few pictures of it if needed. Thanks, Jeff

[MECOA]

Need some pictures

[XMoney]

I will post them tonite! Thanks alot.

[XMoney]

I will have to e-mail them to you. There does not seem to be a way to upload the pix. Can Isend them somewhere so you can view them? Thanks, Jeff

[XMoney]

OK ,Try This address to see the pics.


http://s807.photobucket.com/album


Thanks, Jeff

[XMoney]

That is just going to get to the photobucket homepage. Try a search for forkliftman albums . The album of photo's is named ; veco 19 .

[MECOA]

This is an early plain bearing Veco 19. It is an airplane enigne. It looks like you have a prop driver in the picture. All you need is a prop nut and washer.

[XMoney]

I really appreciate the info on the engine. Are you talking about the little 2 piece bearing assy in the photos? If that is the driver , where can I get the washer and nut ? Can I order thru you? What do think about using the engine? It does have good compression. The NVA looks like new. Are there parts available? I did not see any listing on the site . Since some one ground the webs on the crankcase to fit that nose support for the extra mtg. holes, will that weaken the crankcase? I am going to start this engine soon and would like to mount on a plane I am currently working on. Thanks, Jeff