Veco 19 GP BB RC

All outboard, inboard and aero questions answered here.
ALSO Veco, Torpedo, Fury, & Stallion

Moderator: SteveM

Veco 19 GP BB RC

Postby XMoney » Tue May 04, 2010 1:25 pm

Hello, Am new to the forum. I am needing a little help on a Veco 19 GP BB RC . I think this was an engine that was in a car or boat. It came with a big drive pulley, and carb installed with the throttle lever that closes on the exhaust port. My question is : Can this engine be used in aero ? It has a mount that is over the nose of the engine and it has a bearing in it and, it has a set of mtg. holes in it. Can anyone help me out. I can take a few pictures of it if needed. Thanks, Jeff
XMoney
 
Posts: 6
Joined: Tue May 04, 2010 12:09 pm
Location: Missouri

Postby MECOA » Wed May 12, 2010 8:32 pm

Need some pictures
MECOA
Site Admin
 
Posts: 1095
Joined: Mon Jun 30, 2003 9:48 pm

Postby XMoney » Thu May 13, 2010 12:12 pm

I will post them tonite! Thanks alot.
XMoney
 
Posts: 6
Joined: Tue May 04, 2010 12:09 pm
Location: Missouri

Postby XMoney » Fri May 14, 2010 9:29 pm

I will have to e-mail them to you. There does not seem to be a way to upload the pix. Can Isend them somewhere so you can view them? Thanks, Jeff
XMoney
 
Posts: 6
Joined: Tue May 04, 2010 12:09 pm
Location: Missouri

Postby XMoney » Sun May 16, 2010 9:35 pm

OK ,Try This address to see the pics.


http://s807.photobucket.com/album


Thanks, Jeff
XMoney
 
Posts: 6
Joined: Tue May 04, 2010 12:09 pm
Location: Missouri

Postby XMoney » Sun May 16, 2010 9:45 pm

That is just going to get to the photobucket homepage. Try a search for forkliftman albums . The album of photo's is named ; veco 19 .
XMoney
 
Posts: 6
Joined: Tue May 04, 2010 12:09 pm
Location: Missouri

Postby MECOA » Tue May 18, 2010 7:53 pm

This is an early plain bearing Veco 19. It is an airplane enigne. It looks like you have a prop driver in the picture. All you need is a prop nut and washer.
MECOA
Site Admin
 
Posts: 1095
Joined: Mon Jun 30, 2003 9:48 pm

Postby XMoney » Tue May 18, 2010 8:31 pm

I really appreciate the info on the engine. Are you talking about the little 2 piece bearing assy in the photos? If that is the driver , where can I get the washer and nut ? Can I order thru you? What do think about using the engine? It does have good compression. The NVA looks like new. Are there parts available? I did not see any listing on the site . Since some one ground the webs on the crankcase to fit that nose support for the extra mtg. holes, will that weaken the crankcase? I am going to start this engine soon and would like to mount on a plane I am currently working on. Thanks, Jeff
XMoney
 
Posts: 6
Joined: Tue May 04, 2010 12:09 pm
Location: Missouri


Return to K&B Mfg. Engine Tech Questions

Who is online

Users browsing this forum: No registered users and 0 guests