Bearings for a K&B 6.5 marine

All outboard, inboard and aero questions answered here.
ALSO Veco, Torpedo, Fury, & Stallion

Moderator: SteveM

Bearings for a K&B 6.5 marine

Postby James C Harrell » Mon Feb 20, 2012 12:16 am

I have a K&B 6.5 marine I was attempting to break in. The pinch was real tight so I was taking it slow when I felt a bad feeling. It felt like a bearing so I pulled it down and did find a bearing that had a slight bad spot. It wasn't near as bad as it seemed like but still bad enough. Problem I have is that the bearings listed for the 7.5 family are not the right dimesions. The serial number on my engine is 0002393 and it is a 6.5. Both the front and rear bearings are the same size. Best I can figure is 22.11mm OD and 9.75 ID and 5.76 thick. Is there any way to make sure befor I buy this size or can I get them from Mecoa?
James C Harrell
 
Posts: 7
Joined: Tue Jan 31, 2012 4:58 am
Location: USA

Postby James C Harrell » Mon Feb 20, 2012 12:27 am

Made a mistake on the measurements. They should read as: OD 22.2mm, ID 9.5mm, and 5.5mm thick. Also both of these are non-sealed.Is that right?
James C Harrell
 
Posts: 7
Joined: Tue Jan 31, 2012 4:58 am
Location: USA

Postby MECOA » Tue Mar 06, 2012 7:24 pm

It would be our part numbers
18-0015
18-8778

inch size
BEARING .875 x .375 x .218

you can find them here


http://shop.mecoa.com/shopsearch.asp
MECOA
Site Admin
 
Posts: 1095
Joined: Mon Jun 30, 2003 9:48 pm


Return to K&B Mfg. Engine Tech Questions

Who is online

Users browsing this forum: Google [Bot] and 19 guests

cron