by WaltEagles24 » Fri Jul 17, 2009 1:22 pm
OK so it sounds like the head is from the .19 engine, the crankshaft is either for the .19 or .23 (can't determine at this point), and the cylinder is unknown also. Please note that I only paid .99 cents for this mess so no big loss if it becomes a parts engine but I like a challenge.
After I cleaned it up and put new gaskets on it I tried it to see what kind of compression I had, which was none. The piston had a lot of slop in it which makes me wonder if the piston was originally from a .19 and the cylinder from a .23. Without specs on the dimentions of piston, cylinder, and crank there is no way to tell what the parts belong to what engine.
Anyone out there know where I can get the specs?